Mounts to a flat surface:
- Twist the cover clockwise to remove the base.
- Place one long screw through the center hole of the base.
- Tighten until the head of the screw is flat with the base.
- Do not overtighten.
OR Mounts to a wall or post:
- Slide the mounting bracket down and remove from the cover.
- Take note of the UP ARROW on the back of the bracket.
- Find a shaded location and attach the bracket (arrow UP) with the four screws (included), or with the two zip ties (included).
- Note: Allow room to slide cover onto bracket.
- Slide the shield down onto the bracket.
Insert a Sensor for Protection from the Elements:
- Twist the cover clockwise to remove the base.
- Attach the Velcro tape to the sensor and to the upright on the base. This keeps the sensor from tipping.
- Alternately, secure the sensor with a zip tie.
- With a probe sensor, be sure the probe wire fits through the round hole in the base.
- Place cover over sensor and base. Twist counter clockwise to lock into place. Sensor must fit entirely in the sensor shield to be protected.
- Mount the sensor shield so that the sensor is in range of the display.
